|
Bad Duino by rv6502 [web]
[nfo]
|
||||||||
|---|---|---|---|---|---|---|---|---|
|
|
|||||||
|
popularity : 51% |
|||||||
alltime top: #33604 |
|
|||||||
|
||||||||
added on the 2018-01-22 06:45:35 by rv6502  |
||||||||
popularity helper
comments
Ack! sorry I mixed up the resistors: pin 53 (video) is 470 Ohm, pin 52 (sync) is 1K.
Derp derp.
The video plays really dark if they're swapped but nothing will blow up. No harm. Just my bruised ego :)
Derp derp.
The video plays really dark if they're swapped but nothing will blow up. No harm. Just my bruised ego :)
nice to see it on arduino! greyscale part of the video looks crappy though :(
some guys on other platforms been getting better results doing velocity differences per frame compression only (read about it on an how to article of one of the atari st versions i believe). you might want to try that to improve framerate. :)
some guys on other platforms been getting better results doing velocity differences per frame compression only (read about it on an how to article of one of the atari st versions i believe). you might want to try that to improve framerate. :)
nice one!
Encoder needs work
Hahaha!
Good conversion and nice result, dude =). Congratulations =)
Good conversion and nice result, dude =). Congratulations =)
submit changes
if this prod is a fake, some info is false or the download link is broken,
do not post about it in the comments, it will get lost.
instead, click here !
And instructions to hook up on my blog for those who want to run it on their Arduino mega 2560: https://rv6502.ca/post/2018/01/22/bad-duino-bad-apple-on-arduino/
Two resistors: 1K Ohm to pin 53, 470 Ohm to 52, connect both to the monitor's composite input (centre pin). And don't forget the ground too (connector's outside ring / shield).